Infocus DISPLAY LINK IN3104 Instrukcja Użytkownika Pobierz pdf (Strona 4)

Turn on projector and source

Connect the power cord to the projector

and to an electrical outlet

The power light on the projector will light amber.

Remove the lens cap

Turn on the projector

Touch the power light (or press power on the remote).

The power light will start blinking green.

Wait for the lamp to warm up

After a few seconds, the power light will stop blinking, and the

other buttons on the keypad will light up. It can take a minute

for the lamp to reach full brightness.

Warning: Do not look directly into the lens

when the projector is turned on.

Turn on computer or other source

If your computer is connected to the DisplayLink connector,

follow the instructions on your computer's screen. Otherwise,

you may need to press a speciﬁc key combination to activate

your laptop's external video port. On most laptops, hold down

the FN key while pressing a key labeled CRT/LCD, LCD/VGA, a

monitor icon , or similar. Key combos for popular models:

Apple F7 Gateway Fn+F3 or Fn+F4 IBM ThinkPad Fn+F7

Dell Fn+F8 HP/Compaq Fn+F4 or Fn+F6 Toshiba Fn+F5

Fujitsu Fn+F10 Sony Fn+F7

Complete laptop activation chart at www.infocus.com/support

Important: If there is still no video, restart your

computer (ﬁrst make sure it's connected to the

projector and the projector is turned on).

Change source if needed

If needed, press source (on the projector or remote) to view the

source. You may have to press it more than once.

TURN OVER

5-10 sec.

source

1 2 3 4 5 6 7 8

Brak uwag

Infocus DISPLAY LINK IN3104 Instrukcja Użytkownika Strona 4